Tractor-Size › Guides

Front/rear tire ratio on 4WD tractors

What happens if the front/rear outside-diameter ratio changes when you replace tires on a 4WD tractor.

In short
  • On 4WD the front axle turns slightly faster than the rear.
  • The ratio comes from rear and front rolling circumferences.
  • A wrong ratio wears tyres and driveline.
  • When changing tyres, pick a pair close to a factory pair.

In short

On a 4WD tractor the front wheels turn slightly faster than the rear (the factory usually sets a small lead of about 1–5%). This is calculated from the rolling circumference of the front and rear tires.

If the ratio is off

What to do

Choose a new front/rear pair with a ratio close to one of the factory pairs. Use the 4WD match check on the home page.

How the ratio is calculated

Divide the rear tyre's rolling circumference by the front tyre's. If the rear covers 4.4 m per turn and the front 2.9 m, the ratio is about 1.52. The factory sets the driveline gearing to match this value, and a new tyre pair should not differ from a factory pair by more than a few percent.

Why small differences matter

A 2–3% difference sounds small, but it means the front wheel travels a few centimetres more or less than the rear on every turn. Soft soil tolerates some of this, but on tarmac and hard ground the tyres scrub and the driveline is wound up. Over time the front differential and 4WD clutch suffer.

When to pay attention

Common causes of a wrong ratio

When to engage front drive

Use front drive in the field when traction is needed and disengage it on roads and hard surfaces. Even with the right ratio, leaving it on wears tyres and driveline.

Worn tyres and the ratio

The ratio changes with wear as well as size. As tread wears, outside diameter shrinks. New fronts next to heavily worn rears can shift the ratio even when the sizes are a factory pair, so front and rear wear levels should be similar. If the rears are nearly finished, consider them before replacing the fronts. If you must replace one axle only, measure the new tyre's diameter, compare it with the old one and discuss the difference with your dealer.

Frequently asked questions

Why do the front wheels turn faster on a 4WD tractor?

The factory gives the front axle a small lead so the fronts pull the tractor slightly and keep traction in turns.

Can I replace only the front tyres?

Yes, but the new fronts must have an outside diameter close to the old ones or the ratio changes.

How do I check the ratio?

Use the 4WD match tool on the home page: pick your tractor and the tyres you are considering and compare with factory pairs.

What happens if the ratio is wrong?

Fast tyre wear, strain on the front axle and 4WD clutch, and higher fuel use, leading to costly repairs over time.

Published: 2026-09-25 · Updated: 2026-11-13

Guides

Was this useful?Can't find your model or size? Tell us and we'll add it →