Tractor-Size › Guides

Radial vs bias-ply tractor tires

How radial and bias-ply tractor tires differ, and whether one can replace the other.

In short
  • Radial (tubeless) tyres usually pull better and compact soil less.
  • Bias (tube-type) tyres cost less and have tougher sidewalls.
  • Never mix the two on one axle.
  • When switching, recheck rim condition, outside diameter and pressure.

Construction

In a bias-ply tire the plies cross each other, so sidewall and tread stiffen together. In a radial the plies run straight across and the tread is braced by belts, so the sidewall flexes and the tread stays flat on the ground.

In the field

Can one replace the other?

Sizes on the same rim with a similar outside diameter are commonly interchanged (e.g. 14.9-28 ↔ 380/85R28). On 4WD keep the front/rear ratio. See the equivalents table.

Never mix radial and bias tires on the same axle.

Which should you choose?

If the tractor works many hours a year, does heavy draft work and fuel is a significant cost, a radial (tubeless) tyre is usually more economical in the long run: less slip, less fuel and longer tread life. If the tractor works little, runs on stony or scrubby ground, or the budget is tight, a bias (tube-type) tyre can be a sensible choice: it costs less to buy and its sidewalls resist knocks better.

Rim compatibility

A tubeless tyre needs a sound rim that holds air. On old, rusty or welded rims a tubeless tyre may leak; in that case it can be run with an inner tube. A tyre built as tube-type (TT) must always be used with a tube.

Maintenance differences

In tube-type tyres air loss usually comes from a small hole in the tube or a valve fault, and the fix is a patch or a new tube. In tubeless tyres leaks typically come from the bead seat, the valve body or a tread puncture, so a clean, true rim matters more.

Pressure differences

Radials are designed to run at lower pressure; the right value depends on load and speed and comes from the maker's table. Bias tyres run at higher pressure. Never use one value for both.

Checklist when switching

If you plan to move from tube-type to tubeless, first have the rim checked: it must be clean, true and airtight. Then compare the outside diameter and width of the equivalent size with your current tyre; the new tyre must not rub on fenders, frame or front wheels when turning. On a 4WD tractor think about front and rear together, since converting only the rear can change ratio and handling. Finally, take pressures from the new tyre maker's table rather than reusing bias-tyre values. These checks make the switch safe and worthwhile.

Frequently asked questions

Can a tubeless tyre be fitted with a tube?

Yes, if the rim leaks a tubeless tyre can be run with a correctly sized tube fitted by a tyre shop.

Can tube-type and tubeless go on one axle?

No. Do not mix radial and bias tyres on the same axle; their flex and rolling circumference differ.

Which lasts longer?

Radials generally give longer tread life, but use, pressure and ground conditions change this a lot.

Where can I find an equivalent size?

Use the radial ↔ bias equivalents table on this site and confirm the outside diameter with your dealer.

Published: 2026-09-25 · Updated: 2026-11-13

Guides

Was this useful?Can't find your model or size? Tell us and we'll add it →