Tractor-Size › Guides

What to check when buying tractor tyres

Correct size, construction, tread, load index, manufacture date and replacing in pairs: a buying checklist.

In short
  • Find the factory size first.
  • Check construction, tread, load index and speed symbol.
  • On 4WD keep the front–rear ratio.
  • Check the manufacture date and the rim.

Tractor tyres are expensive and the wrong choice costs money and strains the tractor. Knowing the points below before visiting the dealer makes the right choice easier.

1. Know the factory size

Find the size the tractor left the factory with: read the current sidewall or look your model up on Tractor-Size. A previous owner may have fitted a different size, so compare both. See how to read a tyre size.

2. Radial or bias?

Radials win on traction, soil protection and life; bias tyres are cheaper. Never mix constructions on one axle. See radial vs bias.

3. The right tread

R-1W suits most field work; consider R-4 for road-heavy or loader tractors and R-3 for turf. See tread codes.

4. Load index and speed

The new tyre's load index (or PR) should not be lower than the factory tyre's, and its speed symbol must suit the tractor's road speed. See load index and speed symbol.

5. Keep the 4WD ratio

If replacing only fronts or rears, the new outside diameter must be close to the old one or the front–rear ratio changes. See 4WD ratio.

6. Check the date

Look at the DOT date and avoid tyres that sat in storage for a very long time. See tyre age (DOT).

7. Don't forget the rim

Have the rim checked for cracks, dents and rust, and confirm rim width if going wider. See rim width.

8. Replace in pairs

Replacing both tyres on an axle gives equal diameter and traction on both sides. If only one is replaced and wear differs a lot from the other, replace both.

What to bring to the dealer

A photo of the current sidewall, the tractor's make and model and whether it is 2WD or 4WD speed things up. On 4WD note both front and rear sizes so the dealer can check size and ratio together.

Warranty and fitting

Ask about warranty terms and who will fit the tyres. Large tractor tyres need special equipment, and poor fitting can damage tyre and rim. After fitting, make sure pressure is set correctly and wheel nuts are torqued properly, and recheck the nuts after some use.

Frequently asked questions

What should I check first when buying tractor tyres?

The factory size: read the current sidewall or look up your model on this site.

Are cheap tyres a good idea?

On a lightly used tractor an economical tyre can make sense; on a busy one traction, fuel and life matter more.

Can I switch to a different size?

Often, if rim diameter is the same, outside diameter is close and rim width suits. On 4WD keep the ratio.

Should I check the manufacture date?

Yes. The last four DOT digits give week and year; avoid tyres stored for very long.

Is buying tyres online sensible?

It helps compare prices, but talk to a local tyre shop about fitting, warranty and confirming the size.

Published: 2026-11-04 · Updated: 2026-11-13

Guides

Was this useful?Can't find your model or size? Tell us and we'll add it →